Dresser Plan

I get many requests for my modifications to Patrick’s Beach Cottage Dresser as shown in this post.  I finally decided to spend some time modeling it in SketchUp so that I wouldn’t have to keep distributing my hand drawn changes. Download the 3D models here if you’re interested.

Please review the build instructions from the Ana-White.com original plans linked above for the order of construction.

Materials

QtyNominal DimensionLengthUse
22x28'Legs
11x38'Lower side and front rails
21x28'Upper side and front rails
11x103'Top (unless using the 36 1/2" top)
11x123'Top (unless using the 36 1/2" top)
31/4 plywood4'x4'Back and drawer bottoms (can use 1 full sheet and 1 smaller sheet)
13/4 plywood4'x4'Sides
21x88'Finished (outside) drawer faces
51x68'Drawers (each drawer can be made from one board)

Carcass Dimensions

The modifications basically just stretch the cabinet depth to 19″ and add a 5th drawer. The original plans call for the the top to overhang the carcass by 1″ on the three exposed sides (left, right, front).  As shown below, the top is 1″ wider than the base and 1 1/2″ longer on the front.  You can either rip the top down by 1/2″ if you have a table saw, let the top overhang the back by 1/2, or leave the front 1 1/2″ and make the top wider to match.  In the drawing below, the overhang is uneven between the sides and front (1″ and 1 1/2″ respectively). I just use 1x? scraps for the back and top supports.  The dimensions are listed in the following image:

Shoms Dresser

Carcass Cut List

QtyNominal DimensionLengthUse
42x247 1/4"Legs
23/4 plywood16" x 43 3/4"Sides
21x316"Lower side rails
21x216"Upper side rails
11x331"Lower front rail
51x231"Upper front rails
11x1036" OR 36 1/2"Top (edge glue)
11x1236" OR 36 1/2"Top (edge glue)
11/4 plywood31 1/2" x 43"Back

Drawer Dimensions

The drawers are stretched by a few inches as well.  You can actually make them even longer to fill out the back of the cabinet if you want.  I think a 17 1/2″ drawer would fit, but for this case I just used 16″ euro-style drawer slides and a 16″ drawer.  Remember that the drawer faces (1×8) should be attached to the drawer boxes after they are installed to get even spacing around the edges.  Note that the drawer faces are not shown in either drawing.

Shoms Dresser Drawer

Drawer Cut List

QtyNominal DimensionLengthUse
101x616"Drawer sides
101x628 1/2"Drawer fronts & backs
51/4" plywood16" x 30"Drawer bottoms
51x830 3/4"Outside drawer faces

7 Replies to “Dresser Plan”

  1. This dresser is beautiful! I was wondering if you could help me out with some additional modifications. I need a depth around 16″ and need it to be no wider than 34″. I’m still close to the beginner/novice stage and it would be a royal screw up if I tackled those dimensions on my own! THANKS!

Leave a Reply to cookingbeerandlife Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.